Transport and Installation Reels
Transport and Installation Reels required for product installation. Equipment and drums in the size of 12.4m diameter and 5 meter with with a load rating of roughly 250 mTe. Other sized reels will be considered.
Horizontal carousel required with internal diameter (ID) 31m and outer diameter (OD) 40mm and load rating of 425 mTe. MBR of product is 15m.
Wanted Misc. Drilling
Focal 180 Model Slipring
Focal underwater slipring unit required urgently. Moog focal p/n 180-1588-00 suitable for use in a TMS for a Sub-Atlantic Apache ROV or similar.
Self-Propelled Hyperbaric Lifeboat required. Contact us for further details.
5mT Tensioner required with diameter ranges roughly from 100m to 325mm.
Wanted Power Generation
Diesel Generators 400 kw to 500 kw
Diesel Generators 400 kw to 500 kw range duel Frequency 400 Volt 50 Hz, 440 /460 Volt 60 hz. Silenced unit preferred, would consider open unit.
Wanted Power Generation
ALCONZA BERANGO Alternator
We are looking for the following ALCONZA BERANGO Marine Alternator: Model NIR-7185 A-10LW, Rating: 3589 kVA, Voltage: 690V, 60Hz, 720 RPM.
WROV umbilical Winch
WROV compact umbilical winch with SWL 8-10t and minimum 1000 m of umbilical 36 mm dia capacity
Wanted Vessel Part
Ships Helideck required. Must comply with CAP437 Rev. 8. and be large enough to land a Helicopter Augusta AW139 (16.66 diam., 17 D, max take-off weight 7.2t). Contact us for further information.
Flowline for Field Dev. Project
Flex / Umb Vertical Lay System
Looking for a flexible / umbilical Vertical Lay System (VLS) with 50 to 150 mT tension capacity suitable for 4" to approx. 18" OD product.
Prefer a fixed or tiltable system for laying product through a 7.2m x 7.2m vessel moonpool but will also consider a system that needs to be mounted on the vessel side or stern.
Pulled / Used Casing
We are looking to purchase parcels of used / pulled casing tubes ideally in the following sizes.
5 1/2 inch x 17 / 20 / 23 lbs per foot
6 5/8 inch x 24 / 28 lbs per foot
7 inch x 26 / 29 / 32 lbs per foot
7 5/8 inch x 29 / 33 lbs per foot
8 5/8 Inch x 36 / 40 lbs per foot
9 5/8 inch x 47 / 53 lbs per foot
50T Subsea Crane
Seaeye Falcon ROV
we are currently looking for used Seaeye Falcon ROV System, in good working condition" to buy"
Inspection ROV wanted to buy
Looking for a Seaeye Falcon (or similar) inspection-class ROV rated to at least 300m.
1. An ROV LARS with SWL of 1.5T with a platform for the ROV Winch and HPU. ROV umbilical diameter is 16.5mm and total length on the Winch is 400m.
2. ROV cage with clump weight below her, desired dimensions of cage are length:1.55m, width: 1m, height: 1.10m.
3. Framed HPU with redundancy to power the LARS.
Wanted General Marine
High speed gear box
Ratio 2~8,3:1 ,1860 HP @2300 RPM
Wanted Well Operation
Resistance Array Tool
Spares for CAST-V
U31 ACFM Inspection System
U31 Alternating Current Field Measurement (ACFM) required to purchase for underwater use. U41 system also considered.
Umbilical winch required for use as umbilical feeder only, and should be capable of pulling approx 1,500m umbilical of approx 5,4kg/m in seawater. Estimated suitable min lifting capacity approx 10 - 12Ton. Minimum drum diameter to be 172cm minimum and overall dimensions not to exceed 6m (L) x 2.5m (W) x 3m (H) due to road transport limitation). Frame must be sufficient for lifting winch and umbilical payload of approx 10T.